Guts design
This is in prop chat but I thought i would publish it again because i named the topic prop chat and not guts
Materials-----------------------------------------------------------------|
2 cans of great stuff foaming insulation (hardware store,Walmart)
1 can of red spray paint (we prefer darker paint but what ever you think looks nice .)
piece of 2ft by 3 ft. Cardboard
-------------What to do-----------------------------------------------------------------------
Step 1~ First of all do this outside on a table covered with cardboard.
Step 2~ Second Is the preperation Wear gloves . If you don't you will have that stuff on you for about 3 months. (learned that the hard way)
Step 3~ Now Shake can vigorously.
Step 4~This is where you put the straw like part up against the cardboard and start at upper left corner of cardboard Spraying foam to other side just keep going down a section repeat until it is to your liking , but make sure it touches. Get thinner as you go down now just do circles and squiggles in it to give it the really mangled look.
Step 5~ Let it sit to dry,expand and harden.
Step 6~ Now you are ready to have a little bit of gut wrenching fun .
Baldwins Woods
|
Linear Mode
