Thread: Large cylinder pnuematic prop idea

Tweet

I know im early

But my mech doesnt seem to fit the trash can and i have an 18'' cylinder and i want to be creative. I have had a few ideas mostly in the morgue room with the doors and what not. I was thinking maybe using the cylinder horizantal instead of vertical. having something slide out. the problem is the mrgue door thats light foam material how would i get it to close again.

My thought: To have my morgue room wall panels( mostly foam) set up alittle farther from the house so there is space behind in an actor spot... when the actor signals the solenoid would active and push the door open on its hinges and have something lunge out or slide out on a foam slate maybe with a corpsed skeleton or something.

second thought! have a hand or upper torso yo a skeleton slide out from a hole in the wall on peoples walk area so if it were an arm it ould slide out across the walkway scaring people and having them jump back.


3) a skeleton sliding down the hallway with mech attached to ceiling.

Im trying to figure it out and havent seen too many options for a cylinder so large

Thanks,
Chris

where did you find an 18" cylinder? You could use it to make a sit up prop like a body under a sheet that sits up when activated. It would still fit into your morgue scene.