Reply To Thread
Results 1 to 7 of 7
  1. Collapse Details
    Great stuff question
    #1
    MADAM's Avatar
    MADAM is offline Werewolf
    Join Date
    Sep 2009
    Location
    RIVERSIDE, CA
    Posts
    70


    Calling on the powers that be ... your input and suggestions and expertise will be gratefully appreciated. I’d like to make some pvc candles using Great Stuff. I purchased a can moments ago and have read all the label instructions. To my dismay, it says “one time use should be expected.” Have any of you clever folks found a way around this? I’m sure I won’t be using a whole can for a few candles. Thank you in advance for any/all suggestions.
    The Godmother of Halloween~
    Reply With Quote
     

  2. Collapse Details
    #2
    Hyprosick's Avatar
    Hyprosick is offline The Great Pumpkin
    Join Date
    Jun 2010
    Location
    Omaha, Ne
    Posts
    154
    Get rubber gloves when you use it, When you are done you can take the screw cap off and either clean it out with Acetone/Nail polish remover if you can get it in there. Then cover the top of the bottle with plastic. If it does dry up in the top of the bottle or nossle ive used a wire hanger to poke down thru it to free it up again and re-used.

    Thats just my two cents, hope it helps
    Reply With Quote
     

  3. Collapse Details
    #3
    imindless's Avatar
    imindless is offline The Great Pumpkin
    Join Date
    Sep 2010
    Location
    Dallas, TX
    Posts
    279
    After past experiences recently, always use latex rubber gloves like the ones you find at the dollar store and a cheap pair of work glasses. The stuff SUCKS to get on your skin.. I know from experience and a lot of scrubbing and a lot of exposure to nail polish remover.

    I have used it more then once, just clean out the connect sprayer and once dried on the top of the can take off it off easily with your hand.
    Reply With Quote
     

  4. Collapse Details
    #4
    Growler's Avatar
    Growler is offline The Great Pumpkin
    Join Date
    Aug 2008
    Location
    Plymouth, MN USA
    Posts
    1,347
    I've used mine over a week. The stuff will leak out the end after you spray it. So make sure you have paper towel or something to put under the nozzel. I just leave it and it hardens inside. When I need it again, I just cringle the nozzle a little and it loosens it up inside and I just pull the excess out from what is left on the nozzle end. That way it blocks any air from getting all the way in.
    Reply With Quote
     

  5. Collapse Details
    #5
    Jack Skellington's Avatar
    Jack Skellington is offline The Great Pumpkin
    Join Date
    Oct 2005
    Location
    Northern New Jersey
    Posts
    451
    I clean the screw on tube dispenser with some long pipe cleaners I have left over from an old Halloween project. I've used a can over several weeks this way. Gloves are good to wear too when I remember to put them on.
    Boo!
    Reply With Quote
     

  6. Collapse Details
    #6
    Xane is offline Wild Fandango
    Join Date
    Oct 2010
    Posts
    1,358
    I've read that some people stuff a pipe cleaner into it once they're done, then pull it out once it's hardened to use it again.
    Reply With Quote
     

  7. Collapse Details
    #7
    MADAM's Avatar
    MADAM is offline Werewolf
    Join Date
    Sep 2009
    Location
    RIVERSIDE, CA
    Posts
    70
    Re: Reuse of Great Stuff ... I knew I could count on you all for sage advice ... awesome instructions which I most certainly will follow ... thank you for the words of wisdom.
    The Godmother of Halloween~
    Reply With Quote
     

Reply To Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts