Wicc_ed I have my eye slide made to bad I dont have camera.
I got the idea when I saw you slide to use Ball joint and caps. so if you can picture this in your head here goes:
Half eyes fulled with epoxy putty and counter sunk and brass ball connector with the cap sticking out of the putty.I then cut the ball part off the plastic cap and add a small piece of rod with other cap on the opposite end. did this for both eyes Next


I took a piece of rod long enough to make the slide part .and put another ball cap plastic connector on each end. cutting off the plastic tiny ball again and screwing in the tiny trailer hitch part at both ends. But FIRST before you put the second Trailer hitch section on I took one Plastic Ball cap and drill a tiny hole through the ball. and then where the staff is I added a piece of wire for the servo to go to. and slid that to the middle of the wire slide. Then put the second end on. I Hope you got the picture because I have no Camera now Thanks to JTR

I Opened the eye socket up as far as I could nice and round and used the pivot point in middle rod through eyeball method.This is only a 1 axis but thats all I needed for this Prop.

WoW I'm over a 1000 too when I was Blinky the house elf I had someting close to 1500 then I changed My Name